[ARMedslack] libflashplayer

[Davide]

>>> available in source code I don't see why people can assume one can
>>> just drop libflashplayer.so for Android and expect it to work and even
>>> if it did you'd open a can of worms.

>>It does work - I tested it.  I suspect it doesn't work for Davide because
>>the library is compiled for a CPU higher than his own.  This is what I ran
>>it on:

>>root at pepa:~/ac/source/kde# cat /proc/cpuinfo
>>Processor       : ARMv7 Processor rev 0 (v7l)
>>processor       : 0
>>BogoMIPS        : 1987.37

>>processor       :
 1
>>BogoMIPS        : 1993.93

>>Features        : swp half thumb fastmult vfp edsp thumbee vfpv3 vfpv3d16
>>tls
>>CPU implementer : 0x41
>>CPU architecture: 7
>>CPU variant     : 0x1
>>CPU part        : 0xc09
>>CPU revision    : 0

>>Hardware        : trimslice
>>Revision        : 0000
>>Serial          : 0000000000000000
>>root at pepa:~/ac/source/kde#
 
>That's odd: AC100 is a TEGRA2 (Tegra 250 T20) CORTEX-A9 based that only lacks NEON instruntions.
>Unless the library uses NEON instruntions (that I assume is not the sace or the android it came from would not run on any TEGRA2 based device) the most sensible guass I can make is that I need to enable some kernel >options that were left off.

I think I can exclude any kernel options as my cpuinfo only differs from that in Bogomibs and Hardware section
...
BogoMIPS        : 1992.29
...
BogoMIPS        : 1992.29
...
Hardware        : Toshiba AC100/ Dynabook AZ

The rest is exactly the same.

What else could it be ?

Regards
David 

_______________________________________________
ARMedslack mailing list
ARMedslack at lists.armedslack.org
http://lists.armedslack.org/mailman/listinfo/armedslack
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.armedslack.org/pipermail/armedslack/attachments/20120702/6c1152b5/attachment.html>